Water leaks at Y connector

Last Update date : 2014.12.30

comment 

If you are connecting the water lines to your steam washer and dryer, and there is a leak at the "Y" connector, do the following:

    1. Turn off the cold water source valve.

    2. Remove both water lines from the "Y" connector by turning them counter clockwise.

    3. Then unscrew the "Y" connector from the back of your washing machine by turning the "Y" connector counter clockwise.

    4. Inspect the rubber seal for proper placement. If the rubber seal is not positioned properly, it will look like the image below and cause a leak.

    5. Remove and reinstall the seal. When the seal is properly installed, it will look like the image below.

    6. Reinstall the "Y" connector on the cold water inlet on the washing machine.

      Important

      Tighten the "Y" connector hand tight, then use a suitable tool, such as pliers, and tighten an additional 1/4 turn.

      • Reinstall both water lines to the "Y" connector

      • Turn the cold water source valve counter clockwise to the full open position.

      • Check for leaks.

 

Contents Satisfaction Survey

Q1. Is this content helpful?

Q2. How satisfied were you with this content?

Q3. Tell us what you think. What could we have done to answer your question better?

How would you like to contact us for support?

Samsung has launched Carry-in Online Appointment Service to save your time on making appointments for repair, maintenance and firmware upgrade!  Experience Now!

Share this item

Close Share pop-up

Thank you!

We appreciate you filling in this questionnaire and thank you for helping us improve the Samsung.com website.

ok