How to Clean the Inlet Water Supply Filters In Samsung Washing Machines.

Last Update date : 2017.10.02

* Please note, this section is designed to give you basic product troubleshooting information, also refer to your user manual for more information.

 

 

To clean the inlet water supply filters follow the steps below:

 

Step 1: Remove the hot and cold water inlet supply hoses from the back of the washing machine.


Step 2: Locate the inlet hose filter inside of the hot and cold water inlets on the back of the washing machine.

 

                           

 


Step 3: Remove the filters by pulling them straight out by the tab in the center of the filters.

 

                           

 


Tip: You may need to use needle nosed pliers to remove the filters as they are very small.


Step 4: Run the filters under warm water and gently scrub until any visible debris is removed. Be careful not to damage the filter screens. If damaged they will need to be replaced before using the machine again.


Step 5: Place the filters back into the inlets on the back of the washing machine.


Important: When re-installing the inlet hose filters make sure the tabs on the filters are facing outward.

 

 

** "To aid us in creating better support content for you, kindly complete the survey below if your query was resolved. Your rating and comments should only be based on the above content.

For all other queries or further technical assistance, please call Samsung Customer Care on 0800 726 786 or Live Chat with our Technical Team online, services are open 24 hours, 7 days."

 

 

Contents Satisfaction Survey

Q1. Is this content helpful?

Q2. How satisfied were you with this content?

Q3. Tell us what you think. What could we have done to answer your question better?

Need Service? Service Center Locations

Share this item

Close Share pop-up

Thank you!

We appreciate you filling in this questionnaire and thank you for helping us improve the Samsung.com website.

ok