All Samsung Steam Dryers Require A Water Line

The steam dryer must be connected to a cold water faucet for the dryer to operate properly. You can connect your dryer in one of two ways.

  • Connecting The Dryer (Method 1)

    The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.

    1. If space permits, attach the brass female end of the "Y" connector to the cold water faucet.



    2. Turn the cold water faucet off.

    3. Attach the straight end of long hose to "Y" connector.

    4. Using pliers, tighten the coupling with an additional two-thirds turn.

      Note: Do not overtighten, as it may damage the coupling.

    5. Attach angled end of long hoses to fill the valve at the bottom of the dryer's rear frame. Screw on coupling by hand until it is seated on fill valve connector.



    6. Using pliers, tighten the coupling with an additional two-thirds turn.

      Note: Do not overtighten, as it may damage the coupling.

    7. Check that the water faucets are on.

    8. Check for leaks around "Y" connector, faucets and hoses.
  • Connecting The Dryer (Method 2)

    The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.

    1. If "Y" connector cannot be attached directly to the cold water faucet, the short hose must be used.

    2. Turn the cold water faucet off.

    3. Attach short inlet hose to cold water faucet. Screw on coupling by hand until it is seated on the faucet.

    4. Using pliers, tighten the coupling with an additional two-thirds turn.

      Note: Do not overtighten, as it may damage the coupling.

    5. Attach "Y" connector to brass male end of small hose. Screw on coupling by hand until it is seated on connector.



    6. Using pliers, tighten the coupling with an additional two-thirds turn.

      Note: Do not overtighten, as it may damage the coupling.

    7. Attach angled end of long hoses to fill valve at bottom of dryer rear frame. Screw on coupling by hand until it is seated on fill valve connector.



    8. Using pliers, tighten the coupling with an additional two-thirds turn.

      Note: Do not overtighten, as it may damage the coupling.

    9. Check that water faucets are on.

    10. Check for leaks around "Y" connector, faucet and hoses.

Email a Friend