How To Connect Your HW-E350 Sound Bar To Your TV Or External Device Using The Bundled Audio Cable
Page 1. Connections
You will need the Stereo to RCA cable bundled with
your Sound Bar.
off your Sound Bar, TV and external device before making any
connect your external device follow the steps below.
the Stereo end to Audio IN port on the back of the Sound Bar.
the white and red RCA ends to the corresponding white and red Audio
OUT ports on the back of your device. For example, if you are connecting
a cable box or satellite receiver connect the red and white cable ends
to AUDIO on the back of the cable box or receiver. This will send
analog audio OUT from the cable box or receiver IN to the Sound bar.
power on your external device followed by your TV and Sound Bar. Press
the Sat Source button on the Sound Bar remote control or touch Sat Source
on the front panel repeatedly until the front display reads 'AUX'.
The audio of the connected device will output within 4-5 seconds.
If you experience any
static, or hear a buzzing or humming noise coming through your speakers, check the cable connections again and be sure you have the red
and white cables properly connected to the Audio OUT from the TV or
you power on the Sound Bar there will be a 4-5 second delay before it
reproduces sound as it receives and processes audio from the connected
device(s). This is normal.
you select 'AUX' without connecting the Audio Cable, the Sound bar
will power off automatically after 20 minutes since it's not receiving
an audio signal and to conserve power.