How to Install AirDresser

There are certain precautions to follow while installing Samsung AirDresser. Proper installation will ensure the AirDresser operation at its peak performance

Space for Installation

The minimum distance required between the AirDresser and the wall for safe, normal operation is as below:

• AirDresser top – Wall: 25 mm
  
• AirDresser side – Wall: 5 mm
• AirDresser rear – Wall: 15 mm

Precautions Before Installation

• Install it on a hard and level floor. Otherwise it may cause abnormal vibration, noise, or breakdown.
• Avoid direct sunlight and humid places, and install in a well-ventilated place.
• Avoid places near heating apparatus such as heaters. Do not block the ventilation holes on the bottom of the product.
• Do not install the product where it can get frost. Cold water can damage the product.
• This device must not be powered by outside transfer devices such as timers and must not be connected to circuits which are regularly switched on and off by the facilities as it can reset the overtemperature prevention device inadvertently.
• If the temperature is low enough to cause frost, water in the hose may freeze and the product may not operate properly.
• Please install in an environment of 10-35 degrees Celsius.
• If the ambient temperature is low, it may cause product damage or deterioration.

Levelling

There is a potential for the AirDresser to tip-over due to external force or children. If necessary, use the anti-tip-strap to secure the AirDresser and prevent tip-over. Refer to the figure below.