Installing the AirDresser

Last Update date : Oct 18. 2021

Information Icon Please Note: The information on this page is for Australian products only. Models, sequences, error codes or settings will vary depending on location and/or where the product had been purchased. To be redirected to your local support page please click here.

When you are getting ready to install your Samsung AirDresser, there are certain precautions to follow so your AirDresser maintains operating at it’s peak performance. Once you install the AirDresser correctly the first time, no more adjustments should need to be made after that, so you can kick back and relax.

Space for Installation

The minimum distance required for between the AirDresser and the wall for safe, normal operation is as below:

  • AirDresser top – Wall: 25 mm
  • AirDresser side – Wall: 5 mm
  • AirDresser rear – Wall: 15 mm
Samsung Air Dresser spacing specs.
Model: DF60

A

B

C

D

E

F

G

H

I

J

1850

1814.9

35.1

21.6

1828.4

615

555.5

445

1001

618

Precautions Before Installation

  • Install it on a hard and level floor. Otherwise it may cause abnormal vibration, noise, or breakdown.
  • Avoid direct sunlight and humid places, and install in a well-ventilated place.
  • Avoid places near heating apparatus such as heaters Do not block the ventilation holes on the bottom of the product.
  • Do not install the product where the frost is caught. Cold water can damage the product.
  • To avoid the risk caused by the reset of the overtemperature prevention device inadvertently, this device must not be powered by outside transfer devices such as timers and must not be connected to circuits which are regularly switched on and off by the facilities.
  • If the temperature is low enough to cause frost, water in the hose may freeze and the product may not operate properly.
  • Please install in an environment of 10-35 degrees Celsius.
  • If the ambient temperature is low, it may cause product damage or deterioration.

Levelling

1 Select a solid and level location with adequate space using the above clearances.

  • If the minimum clearances are not met, performance will decrease due to poor ventilation and condensation may occur on the product exterior.
  • Do not install the product in direct sunlight or hot and cold places. The ambient temperature must be between 10 °C – 35 °C. If the ambient temperature is too high or too low, the product may not operate normally or performance may decrease.
2 You need to level the product to ensure the best drying performance.In order to minimize unwanted movement of the product due to vibration or noise, the surface should be completely flat and even.
Levelling leg
3 Before operating or testing, please thoroughly read the electrical requirements.
4 Connect the plug and check the following through operation.

Please Note:

  • After installing the product, you must wait at least 2 hours before using it.
  • The product consumes more water the first time it is used. You may have to fill the Refill Tank more than one time.

Securing the AirDresser with the optional anti-tip strap.

Please Note:

  • Use the provided screw to fasten the anti-tip strap to a wall.
  • Use the screws fastened on top of the AirDresser to fasten the anti-tip strap to the AirDresser.

There is a potential for the AirDresser to tip-over due to external force or children. If necessary, use the anti-tip-strap to secure the AirDresser and prevent tip-over. Refer to the figure below.

Please be advised that you must unplug the product before securing the AirDresser with the anti-tip strap.

anti-tip strap installation.

If you require further assistance, please consult the user manual from our Manuals & Downloads page or contact our Samsung Care Australia experts on 1300 362 603 (Toll Free in Australia). You can also contact our Chat Support team or reach us through Samsung Members Community.

Thank you for your feedback!