Understanding the Icons on your Samsung Dryer
This comprehensive list provides you with the visuals and the explanation for every icon shown on your Samsung Dryer.
This icon indicates Child Lock is turned on. All buttons other than the Power button and the control knob are locked.
This icon indicates Delay Start is in use. A cycle is prepped to start at the specified time.
This icon displays after every load as a reminder to clean the lint filter.
The hourglass icon indicates that the number currently displayed on the panel is the time remaining in the cycle.
This icon indicates the signal sounds (that occur at the end of a cycle) are turned off.
This icon indicates that the Mixed Load Bell option is turned on. The Mixed Load Bell will signal when the cycle is 80% dry. This signal is so you will pause the cycle and remove the lighter, dryer fabrics, allowing the heavier fabrics to finish drying before the cycle ends. If you don't pause the cycle, it will continue normally, and heavier fabrics may not be dry when the cycle ends.
This icon indicates the exhaust vent is in need of cleaning. After or during a cycle, it will light up if the exhaust vent is about 60% clogged. If the exhaust vent is 80% clogged, the icon will blink for 3 hours after a cycle is completed.
This icon indicates the Steam option is turned on. Water will be sprayed during the cycle to achieve a steam effect while heating the laundry.
This icon indicates Smart Care is turned on. Smart Care uses the camera on a mobile device to recognize error codes on the dryer and interpret them.
This icon indicates the dryer is connected to both the wireless network and a mobile device.
The app used to connect to the dryer will vary between models. Most Wi-Fi models support SmartThings, but the required app could also be Samsung Smart Home or Samsung Smart Washer/Dryer.
These icons light or blink to indicate the current status in the cycle. Different models have different behavior, but on most models these lights will stay lit the entire time a cycle is running and the current status will blink.
Thank you for your feedback!