What to do if the water dispensed from your refrigerator is not cool enough

The water temperature of the dispenser should be the same as the water tank temperature. If the water is not cold enough, it may cause the water tank to run out of water. You can try the below instructions at home but if there are still problems with it, please contact to customer's center. 

If the cold water from the water dispenser is no longer cold, you may have used all the water in the refrigerator water tank. In order to get cold water again, you have to wait until the water in the entire tank has been cooled. Please allow time for the refrigerator to chill the water.

Normally, the water tank contains about 2 liters of water and it is located at the back of the lower drawer of the fridge. The cold water temperature must be the same as the fridge compartment.

If the dispenser has not been used recently the first glass of water may not be as cool. The residual water in the water pipe may have warmed up. Dispensers may need approximately 2 to 3 hours to chill the water.

Therefore, please drain the water until cool water comes out from the water tank again.

Discard the first glass of water and dispense enough water (at least 6 glasses) until the fresh and chilled water comes out.

After installation, let the new refrigerator sit for 12 hours. The water in the water dispenser will be chilled when the refrigerator has cool down sufficiently. If necessary, set the temperature lower than 4 °C. Then, the water in the water tank will cool much faster.