Jet Bot LED indicator is blinking while in operation

After 50 minutes of cleaning, the LED will blink blue and an alarm will sound.

1.     Let the main unit recharge until the battery is full. It is recommended to use the Jet Bot on a full battery.

2.     Press and hold the Operation button for 2 seconds to resume cleaning.

The battery level is low. If this occurs when the main unit is cleaning in a dark place, it will move to a brighter area and then stop. You should charge the main unit’s battery before letting it clean again.

The Jet Bot has stopped cleaning in the middle of a cycle. This may happen if:

• The Jet Bot is stuck between obstacles, such as furniture.

Turn off the Jet Bot and check it. After removing any foreign substances, place the Jet Bot in a wide, open area away from obstacles, and then turn it on again to resume cleaning.

There is an issue with the battery. This can be caused by using something other than the provided charging adapter to charge the Jet Bot.

1.     Turn the Jet Bot off, and then turn it on again by pressing and holding the Operation button for 2 seconds.

2.     If the LED still blinks red, turn off the Jet Bot and contact the Support Center for service.