How to Couple or Link a New Replacement Earbud with an Old One

Last Update date : Jul 14. 2023

Even if you have lost one side of your Galaxy Buds set, you don't have to buy a completely new set of earbuds again. Buy one earbud separately and couple it with the remaining one, and you can use them together as a pair again.

Find out how you can link Galaxy Buds that were each purchased from different sets together below.

Before you try out the recommendations below, be sure to check if your device's software and related apps are updated to the latest version. To update your mobile device's software, follow these steps: 

Step 1. Go to Settings > Software update.

Step 2. Tap on Download and install.

Step 3. Follow the on-screen instructions.

Note: The earbuds that your are trying to couple/link should be the same model and of opposite sides e.g. Galaxy Buds Pro left earbud can only be coupled with a Galaxy Buds Pro right earbud

How to sync the earbuds to each other

If you recently damaged or lost one of your earbuds set and bought a replacement, you can easily connect the original earbud to the newly purchased earbud. Coupling is required to adjust the volume and delay between both earbuds. Follow the steps below to self-couple your earbuds.

Step 1. Check the direction of each earbud, the newly purchased earbud and original earbud, and correctly insert them into their corresponding slots in the charging case.

couple new earbud step1

Step 2. Touch and hold both earbuds touch areas for 7 seconds or more. The earbuds battery indicator light will flash green and then return to the initial light. Then, the earbuds are coupled.

couple new earbud step2

Step 3. When the earbuds are coupled, you will be able to reconnect to your compatible devices.

Find out more about how to connect your Galaxy Buds via the Galaxy Wearable app at ‘How to connect and update Galaxy Buds+ with Galaxy Smartphone’ with Samsung Support.

Note: The battery indicator on the charging case will keep flashing red when the earbuds are not coupled properly. Remove the earbuds from the charging case and insert them again.

Additional Tip for self-coupling your earbuds

If you cannot complete coupling with a new earbud, make sure the Block touches feature of the original earbuds is disabled on the Galaxy Wearable app. Try disabling Block touches by following the steps below.

Step 1. Open the Galaxy Wearable app.

Step 2. Tap the switch to disable Block touches.

block touches disable

Note: 

  • If you lost an earbud but still want to use the other one by itself, you can use the single earbud with the device it was previously paired to. However, some features may be unavailable.
  • Device screenshots and menus may vary depending on the device model and software version.

Purchasing one earbud


If you would like to purchase one replacement earbud, you may call 1800-4252997 (1800 GALAXY S) to arrange an appointment before heading down to one of our Service Centres.

If you are experiencing difficulties with your Samsung phones, tablets, or wearables, you can send us a question in the Samsung Members app.

This allows us to take a closer look at what is happening. The data is anonymised and only held for the duration of the investigation. Find out more about sending an error report through the 'How to use the Samsung Members app'.

Exclusive for Your Galaxy

Exclusive for Your Galaxy

Check, Repair, or Replace

Thank you for your feedback!

RC01_Static Content