How to adjust display temperature using a remote control?

How to Change the Display Temperature on AR9500T RAC Using Remote Controller?

If your AR9500T RAC is showing the setting temperature instead of the current room temperature on the display, you can easily switch between the two modes using the remote controller. Follow the steps below to make the change.

1. Steps to Change the Display Temperature

1. Turn on the indoor unit of your AR9500T RAC.
2. Press and hold the swing button (left/right) for 5 seconds until you hear a beep. This will switch the display from the setting temperature to the current room temperature.
3. When you adjust the temperature using the remote, the indoor unit will briefly show the setting temperature for 5 seconds before reverting to the current room temperature.

2. Additional Things to Check

- Once the temperature type is changed, it remains in that mode even after turning the unit on/off or unplugging it. To revert to the original mode, repeat the steps above.

- Ensure the remote controller is properly connected and functioning correctly to avoid any issues during the process.

3. Supported Samsung Devices

This guide applies to the AR9500T RAC model. For other Samsung HVAC models, refer to their specific user manuals or support resources.

4. Why the Issue Happens

- The default display setting may show the setting temperature instead of the current room temperature due to factory defaults or user preferences.

- Intermittent issues may arise from remote controller malfunctions or display board errors.

5. Related Samsung Support Topics

- How to troubleshoot remote controller issues on Samsung HVAC systems

- How to reset the indoor unit display on Samsung air conditioners

- How to check and maintain the indoor unit display board