How to properly maintain a Samsung Top Load Washing Machine
Last Update date : 2023-06-11
Keep the washing machine clean to prevent deteriorated performance and to preserve its life cycle.
Eco Tub Clean reminder
- The ECO TUB CLEAN LED blinks on the control panel to remind you to clean the tub. If you happen to see the indicator blinking after washing is complete, remove the laundry and run the Eco Tub Clean cycle.
- You can ignore this reminder and continue to run cycles normally because this is not a system failure. However, the reminder remains active for 6 consecutive cycles immediately after each cycle is complete.
- The reminder is activated once every 1-3 months, depending on the cycle count.
- To keep the tub clean, it is recommended to run Eco Tub Clean on a regular basis
Lint filter
1
Press down the upper area of the filter case to remove.
![Lint filter]()
2
Unlock the cover, and clean the filter with running water and a brush.
![Lint filter]()
3
Once the filter case has been thoroughly cleaned, replace it in its original position and shut the cover. When the filter housing slides in, you will hear a clicking sound.
![Lint filter]()
Pump filter
1
Put a floor-cloth or towel under the Pump filter. Turn the filter knob anticlockwise to remove.
![Pump filter]()
2
Clean the filter with running water and a soft brush.
![Pump filter]()
3
Reinsert the filter, and turn clockwise until it locks into position.
![]()
Mesh filter
1
Turn off the water supply to the washing machine.
![water supply]()
2
Disconnect the water supply hose.
![water supply hose]()
3
Use pliers to pull out the mesh filter from inside the water inlet as shown.
![Mesh filter]()
4
Use a soft brush to clean the filter with running water.
5
Reinsert the filter. Make sure it is tightened against water leaks.
Detergent drawer
1
Slightly lift up the front edge of the drawer, and then slide it open.
![Detergent drawer]()
2
Remove the wing distributor (A) and rinse the cap (B) from the drawer.
![Detergent drawer]()
3
Clean the drawer as well as the distributor and rinse cap with running water and a soft brush.
![Detergent drawer]()
4
When complete, close the rinse cap and reinsert the distributor. Then, reinsert the detergent drawer.
Note: To book a service visit, please call our contact center to get help about the issue. Our helpful agents will be there to help you.
Thank you for your feedback!
Please answer all questions.