Your Jetbot Mop comes with a few accessories, like mop pads, that need to be attached to the main unit prior to cleaning. Before starting, you should charge the Jetbot Mop and select which mop pads to use.
- Ensure your Jetbot Mop is fully charged before beginning a cleaning cycle. Plug in and charge the Jetbot Mop until the LED indicator light turns off.
- Next, you’ll need to attach the mop pads to the water supply kits. Make sure the mop pads are clean before using them. Two types of mop pads are included:
- Mother yarn mop pad (gray): Perfect for cleaning small, dusty areas and for absorbing spills.
- Microfiber mop (green): Ideal for cleaning hardwood and tile floors.
- Attach the mop pads to the water supply kits using the Velcro sides.
- Next, fill the water supply kits with clean water. Open the rubber cap on the water supply kit, pour in the water, and then close the cap.
Note: Do not use any other liquids when filling the water supply kits.
- Attach the water supply kits to the bottom of the Jetbot Mop by carefully pressing down and turning them to the side. You’ll hear a click when the water supply kits are attached.
- Press and hold the Operation button on the Jetbot Mop for two seconds until you hear a beep and the light stays on.
- If there is any remaining water in the water supply kits after cleaning, remove the kits and drain them.
Depending on the floor's material, you may notice circular marks or streaks after cleaning. This is normal and can occur depending on the amount of water used. The marks will disappear by themselves over time. Always make sure you are properly cleaning and maintaining the Jetbot Mop.
