Samsung washing machine will not drain

If you receive a no drain or overflow error, water does not drain, or if it overflows from the washer, follow the instructions in this guide to get your washer draining water again.
Transparent view of top load Samsung washer filling with water.
Transparent view of top load Samsung washer filling with water.

Samsung washing machine will not drain

Caution
If a cycle with hot water temperature settings (such as Pure Cycle or Sanitize) was run recently, the water in the washer may be very hot. Allow approximately one hour for the water to cool before performing this procedure to avoid possible injury.
1

Turn off the washer and check the level.

If the washer isn't level it may not drain correctly. Make sure your washer is level.
Caution
Do not remove the screw on the back of the washer that holds the drain hose against the washer. If the screw has been removed, screw it and the holder back in with any screw that fits. If the holder is missing, service is required.
2

Inspect the drain hose.

Incorrect drain hose installation is the most common reason for drain issues, and service is rarely required. For more information, the full installation instructions are available in the user manual.

Verify the drain hose:

  • Is not inserted less than 6 inches or more than 8 inches into the standpipe or sink
  • Is secured so it will not slip down farther
  • Does not form an airtight connection
  • Is not kinked, bent, or damaged
  • Is at least 18 inches high (24 inches for wash basins)
  • Is not higher than 96 inches (35 inches for wash basins)
  • Is not using a drain hose extension kit
    Washer inspect the drain hose.
3

Clean the pump filter (front loaders only).

Although all the steps in this guide apply to both front and top loaders, this step only applies to front loaders, since top loaders do not have a removable pump filter.

Clean the pump filter periodically to improve cleaning performance and help prevent odors. A clogged debris filter reduces the effectiveness of the draining system.

4

Turn the washer back on and start a cycle.

The washer should drain at the beginning of the test cycle. If it does not, visit our Support Center to request service.
Recommended Articles
Samsung washing machine buttons won't work
Samsung washing machine buttons won't work
If your washer won't start, the buttons won't work, or the control knob won't select a different cycle, you probably have Child Lock turned on. If your Child Lock icon is lit or flashing, this confirms it. Turning Child Lock off will usually take care of your problem.
 Samsung washing machine or laundry smells bad
Samsung washing machine or laundry smells bad
When your Samsung washer or laundry has a musty, moldy, or foul odor, it’s important to address the source quickly. Odors can be caused by improper drain hose setup, detergent buildup, or leaving wet clothes in the machine. Routine cleaning, proper detergent use, and drying the washer can help eliminate odors and prevent them from returning.
 Samsung washer door is locked
Samsung washer door is locked
Your washer door locks to prevent water from coming out (especially for front load models). Child Lock also will lock the door on some models, like front loaders. Normally waiting for the cycle to end is all you need to do to unlock the door, or turn your washer on if it's off. If you get stuck, though, you can drain the water from front load washe
Was this content helpful?
We're here for you

Contact Samsung Support

Contact us online through chat and get support from an expert on your computer, mobile device or tablet. Support is also available on your mobile device through the Samsung Members App.
Get support
auto-contact_us-pc-2x auto-contact_us-pc-2x
flag
Go to site