How do I install my Evolution Kit on my ES7000 or ES8000 TV?
If you own an ES7000 or ES8000 TV you can have all the functionality of the F range Smart Hub by installing an Evolution Kit on your TV. Follow the steps below to do so:
a) Remove the sticky label from the back of the set that has Evolution Kit written on it.
b) Remove the rubber cover from the large plug connector on the Evolution kit.
c) Line up the Evolution Kit with the two slots as shown in the diagram and insert it.
d) Swing the Evolution Kit round into place as if closing a door. This will line the large connector on the Evolution Kit up with the large socket on the rear of the set.
e) Ensure the Evolution Kit is attached securely by pushing it towards the rear of the TV until you feel a click (you will need to support the TV while you are pushing against it). You can check the Evolution Kit is installed correctly by gently pulling the right hand side: if the kit comes away from the rear of the set then repeat steps a through to c. If installed correctly the kit will not move.